IJERT-EMS
IJERT-EMS

Selection Guide for Low Voltage Surge Protector


Selection Guide for Low Voltage Surge Protector
Authors : Quyen Huy Anh, Le Quang Trung
Publication Date: 10-10-2017

Authors

Author(s):  Quyen Huy Anh, Le Quang Trung

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 6 - Issue. 10 , October - 2017

e-ISSN:   2278-0181

Abstract

Proper sizing the low voltage surge protective device (SPD), fabricated by metal oxide varistor (MOV) technology, will guarantee protection efficiency, so this paper focused on researching and developing in-deep study of some main points as follows: The coefficient of conversion between the surge rated current of 8/20μs waveform and of 10/350μs waveform, based on the equivalent of energy absorption; the ageing characteristic of MOV for 8/20μs waveform (instead of 2ms square waveform); determining the surge rated current of low voltage SPD, fabricated by multi block MOV technology, based on the attenuation coefficient of surge dissipation ability between metal oxide varistors, connected in parallel with different tolerance of threshold voltage.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     21
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book