IJERT-EMS
IJERT-EMS

Adsorption of Methyl Orange Dye Using Fe-Mn Composite Powder as Adsorbent


Adsorption of Methyl Orange Dye Using Fe-Mn Composite Powder as Adsorbent
Authors : Akash Deb
Publication Date: 01-09-2017

Authors

Author(s):  Akash Deb

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 6 - Issue. 08 , August - 2017

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV6IS080223

Abstract

In this study Fe-Mn composite powder was synthesized and used as an adsorbent for the removal of Methyl Orange (MO) from aqueous solution. The effect of various parameters such as pH (2.0-8.0), contact time (2 to 30 min), adsorbent dose (0.25-1g/L) and initial concentration of dye (40-140 mg/L) on the adsorption process were studied. The optimum removal of the MO was at low pH (pH=2.0) and at with an initial concentration of 140 mg/L. CR removal of 85.93 % was achieved within 30 min. The maximum capacity of the adsorbent was found 405.11 mg/g. The experimental results were best fitted by Langmuir isotherm. Langmuir adsorption isotherm model reflects monolayer adsorption and adsorption takes place at specific homogeneous sites within the adsorbent. The adsorption kinetics was well described by pseudo-second-order reaction model. Pseudo-second-order model suggested that adsorption is chemisorptions in nature.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     7
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book