IJERT-EMS
IJERT-EMS

Study of Pumping Methods In Erbium Doped Fiber Amplifier (EDFA)


Study of Pumping Methods In Erbium Doped Fiber Amplifier (EDFA)
Authors : Hasanuzzaman, Mijanur Rahim, Mafikul Islam, Md Asraful Sekh
Publication Date: 17-08-2017

Authors

Author(s):  Hasanuzzaman, Mijanur Rahim, Mafikul Islam, Md Asraful Sekh

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 6 - Issue. 08 , August - 2017

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV6IS080128

Abstract

Erbium Doped Fiber Amplifier (EDFA) is an optical amplifier that uses a doped optical fiber as a gain medium to amplify an optical signal. A single EDFA is used for simultaneously amplifying many data channels at different wavelengths within the gain region. The signal which is to be amplified and pump power is multiplexed into the doped fiber and the signal is amplified because of the interaction with the doping ions. In this paper various EDFA pumping schemes are studied and analyzed. The analysis is made for high pump power 200mW to 600mW. Standard Erbium Doped Fiber of length 16.2m is used. Input signal power is set at -34dBm at 1550nm. Output power calculated is in the range of 15 to 25dBm, while the noise figure varied between 4.37 to 7.24 dBm. Among the different pumping method it is found that bi-directional pumping method shows best results.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     20
Similar-Paper

7   Paper(s) Found related to your topic:    

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book