IJERT-EMS
IJERT-EMS

Comparison of Wear Rate of Friction Stir Welded 6060Al and Cu with its base Metals


Comparison of Wear Rate of Friction Stir Welded 6060Al and Cu with its base Metals
Authors : Ashish Haribhau Dawne, Prof. D. V. Pendam
Publication Date: 27-06-2017

Authors

Author(s):  Ashish Haribhau Dawne, Prof. D. V. Pendam

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 6 - Issue. 06 , June - 2017

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV6IS060478

Abstract

6060Al and Cu were joined by Friction stir welding process, and its effect on wear rate of the welded and non-welded zones of the joint were studied in this paper. Samples of 12mm in diameter were prepared from welded and non-welded zone for wear testing Pin-on-disc type machine (Model TR-20LE CHM-800, DUCOM) was used for dry sliding wear test in conformity to the ASTM G99 standard, for different loads of 10 and 15 Newton, keeping sliding distance constant. Wear behavior of welded and non-welded zones were determined for the joint and compared on Winducom 2010 software. The lowest wear rate was observed at the welded zone of the joint, whereas at non-welded zone (i.e. base metals) wear rate was more.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     9
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book