IJERT-EMS
IJERT-EMS

Study of Hardness and Optimization of Wear Properties of AL 7075 Hybrid Composite


Study of Hardness and Optimization of Wear Properties of AL 7075 Hybrid Composite
Authors : P. Sandeep Kumar, S. Pichi Reddy , G. Kartheek
Publication Date: 27-06-2017

Authors

Author(s):  P. Sandeep Kumar, S. Pichi Reddy , G. Kartheek

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Volume. 6 - Issue. 06 , June - 2017

e-ISSN:   2278-0181

 DOI:  http://dx.doi.org/10.17577/IJERTV6IS060401

Abstract

Waste sugarcane Bagasse-ash and graphite with different percentages are utilizing as reinforcing material along with Aluminium 7075 matrix material. The selection of bagasse-ash as reinforcement has one of the most significant criteria for the fabrication of Aluminium matrix hybrid composites. Stir casting technique is one of the liquid metallurgical route is used for fabricating the Aluminium 7075 at 800°C. The effect of reinforcement on hardness was measured. Experimentation have been carried out based on standard L9 orthogonal array design with three process parameters namely type of material, load, speed. Optimum parameters were noted for attaining the minimum wear rate of hybrid composites by the application of Taguchi’s technique.

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     27
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book