IJERT-EMS
IJERT-EMS

Analysis Of Injection Moulding Process Parameters


Analysis Of Injection Moulding Process Parameters
Authors : Mr. M.G. Rathi, Mr. Manoj Damodar Salunke
Publication Date: 29-10-2012

Authors

Author(s):  Mr. M.G. Rathi, Mr. Manoj Damodar Salunke

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Vol.1 - Issue 8 (October - 2012)

e-ISSN:   2278-0181

Abstract

In this study, analysis of injection moulding process parameters was carried out to minimize short shots. Optimum level of factors are determined by DOE technique of Taguchi and the analysis of variance (ANOVA) methods. For this study CPVC specimens were tested. Determination of optimum machine settings was based on S/N ratios. According to results mould closing speed had significant effect on quality characteristic. Mould pressure and Injection pressure

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     1473
Similar-Paper

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book