IJERT-EMS
IJERT-EMS

Pneumatic Auto Feed Punching and Riveting Machine


Pneumatic Auto Feed Punching and Riveting Machine
Authors : A.S. Aditya Polapragada, K. Sri Varsha
Publication Date: 25-09-2012

Authors

Author(s):  A.S. Aditya Polapragada, K. Sri Varsha

Published in:   International Journal of Engineering Research & Technology

License:  This work is licensed under a Creative Commons Attribution 4.0 International License.

Website: www.ijert.org

Volume/Issue:   Vol.1 - Issue 7 (September - 2012)

e-ISSN:   2278-0181

Abstract

The pneumatic system has gained a large amount of importance in last few decades. This importance is due to its accuracy and cost. This convenience in operating the pneumatic system has made us to design and fabricate this unit as our project. This unit, as we hope that it can be operated easily with semi skilled operators. The pneumatic press tool has an advantage of working in low pressure, that is even a pressure of 6 bar is enough for operating the unit. The pressurized air passing through the tubes to the cylinder, forces the piston out whose power through the linkage is transmitted to the punch. The work piece thus got is for required dimensions and the piece can be collected through the land clearance provided in the die. The die used in this is fixed such that the die of required shape can be used according to the requirement. This enables us to use different type punch dies resulting in a wide range of products. Different types of punch as requirement can be thus got. According to the work material the operating pressure can be varied

Citations

Number of Citations for this article:  Data not Available

Keywords

Key Word(s):    

Downloads

Number of Downloads:     8312
Similar-Paper

7   Paper(s) Found related to your topic:    

Call for Papers - May - 2017

        

 

                 Call for Thesis - 2017 

     Publish your Ph.D/Master's Thesis Online

              Publish Ph.D Master Thesis Online as Book